Bringing One Back To Life Part 3


After sanding the frame, forks and swing arm, they were wiped down and hung up on the paint racks.  Two coats of Duplicolor primer, two coats of Duplicolor Paint Shop lacquer and three coats of clear were applied and left to dry.  These bikes are nice because there are so few parts to prep for paint.  Painting took place over a period of about 3 hours.  It needs to harden for a week before you can wet sand.  The colour was called deep blue metallic, sold at CTC by the US quart.





Comments

Post a Comment

Popular posts from this blog

Classic Mini bike Engines

Image
Making a Tecumseh Snowblower Engine Look Vintage As a kid, the Honda bikes were what we dreamed of owning.  Their motorcycle feel with steering head bearings and a transmission were high end features in a day when lawnmower type flathead engine powered mini bikes were the norm.  I remember as a kid, looking for the reel type lawnmowers that had horizontal shaft engines.  Hoping to find one no longer being used and pulling the engine off to put on a mini bike I didn’t even have at that point!  They were around in the late 60s, early 70s, but were usually 2 or 2.5 hp maximum.  My first “go kart” was one my Dad built, using parts from an old baby carriage and a sheet of plywood.  I pestered Dad until he finally conceded to find an engine to bolt onto the back of it.  I believe it was 1967 or 1968 in Ancaster when we found an old outdoor wringer washing machine engine.  Yes, gasoline powered washing machines were common up to the 1960s....
Read more

1978 CT70 Resto Mod Part 5

Image
Well, this is the final installment of this bike build.  One other thing to mention is that when fitting a 125 to a CT or and small bike chassis, the foot pegs need an hour or more of “adjustment” with some heat.  This is because the 125 is wider than the 50 or 70 engine.  The bolt pattern for fastening the foot pegs is the same though.  It just takes a bit of work to get them to clear the engine and sit level.  Finishing touches were to install the headlamp and bezel, engine oil and adjust everything.  John V. bought the bike and kept it for a couple years.  Pete bought it from him and rides it regularly.  Pics include John riding it at the sand pit near Norway Bay, being parked up at Bell’s Lake after a day of riding and it loaded with the other 1978 CT70 I fixed up.  It is a fast bike, wheelies with ease and is very reliable.
Read more

1970 Fox Minibike Part 8

Image
I saw a pitbike exhaust online for sale for about $60!  Free delivery, too.  Anyways, once the suspension was figured out, lining up the exhaust system was next. The new larger diameter pipe fit like a charm at the front, but angled upward to much to suit the vintage nature of the bike. It would appear I needed a way to bend the muffler down, but without heating or damaging the chrome on the pipe.  If I cut the pipe ahead of the factory upward bend and fit a sleeve inside the pipe, I could rotate it to the angle I needed.  So, out came the cut off tool and I began.  This would also hide the clamp and cut behind the heat shield. Once clamped and the heat shield was put back on, you’d never know it was bent upwards.  Thanks again to my friend John V for the chrome handle bar pipe and clamp! The rear brake pedal from the pit bike wouldn’t work at all on the Fox bike, so into the parts bin I dug.  I came up with a 1...
Read more